Path in the sky
by Moussa Tarraf · in Marble Blast · 01/06/2005 (2:20 am) · 8 replies
Greetings,
i'm trying to put a bird in the sky and enable it to follow a path like any other aiplayer , but the problem is :
No matter how high is the path drawn (F11-F4) , the bird is always following it on a very low level just above the ground .
Can anyone give me a hand on this ??
Thank you all in advance .
ADAM.
i'm trying to put a bird in the sky and enable it to follow a path like any other aiplayer , but the problem is :
No matter how high is the path drawn (F11-F4) , the bird is always following it on a very low level just above the ground .
Can anyone give me a hand on this ??
Thank you all in advance .
ADAM.
About the author
#3
i did not make the bird myself , i downloaded it from GG.
it was made by " BraveTree" who published a Nature Pack .
ADAM.
01/11/2005 (12:29 am)
Solo ,i did not make the bird myself , i downloaded it from GG.
it was made by " BraveTree" who published a Nature Pack .
ADAM.
#4
i did post my question there , hope to get an answer. :p
thanks .
ADAM.
01/11/2005 (12:36 am)
BOb,i did post my question there , hope to get an answer. :p
thanks .
ADAM.
#6
01/17/2005 (1:29 pm)
I am fairly certain that AIPlayer is not implemented in Marble Blast, as it is not used at all in the game. Mark would really be the one to ask, though.
#7
02/12/2009 (4:51 pm)
I have the same problem.. I also used the naturepack., and the bird is on the ground... I dont know what to do.. any ideas?..
#8
10/01/2010 (5:11 pm)
I am fairly new to torque..... i would think that all you would have to do to make the bird appear to be flying in the air would be to extend the bounds box that is surrounding the model down a bit below the model. put the path on the ground and it will still have the appearance that it is actually following a path in the sky. 
Torque Owner Bob
I would suggest posting this question in the level building forums.
www.garagegames.com/mg/forums/result.forum.php?qf=84
BOb