Problem with Milkshape 3D
by Jovani Adolfo · in Artist Corner · 06/24/2012 (6:22 pm) · 7 replies
I'd like to start off by saying that I have had this problem before I used this PC, (since I have this problem again) After a few months of using MS3D, I just started having this problem where it won't let me zoom in or out in the wireframe viewports; (i.e. front,back,left,right) Not 3D, 3D viewport works. If you could help that'd be awesome.
-Jovani Adolfo
-Jovani Adolfo
#3
06/24/2012 (8:13 pm)
Because there was an artist corner and Milkshape 3D tag, so I just went ahead and posted here, please post something helpful.
#4
06/24/2012 (9:58 pm)
bump 
#5
06/25/2012 (4:28 am)
@Jovani: No sorry ... I have not experienced this issue at all. Have you tried to upgrading your Milkshape ... it is about the only advice that I can think of. 
#6
You may find more help on this issue on the Milkshape 3D official forums.
06/25/2012 (7:47 am)
JovaniYou may find more help on this issue on the Milkshape 3D official forums.
#7
06/25/2012 (10:07 am)
Fixed the problem! Found it on MS3D forums I had to delete the cfg files. 
Torque 3D Owner Jovani Adolfo