Problem with T3D1.1a
by Stefano Santo Sabato · in Verve · 01/17/2010 (4:48 pm) · 4 replies
Hi,
I'm experiencing a crash problem with T3D1.1a putting verve on a project I started.
when I began to load mission T3D crashes. I'm using binary (i'm not compiling)
The verve example (the exe that come with the ) run without problems.
I'm experiencing a crash problem with T3D1.1a putting verve on a project I started.
when I began to load mission T3D crashes. I'm using binary (i'm not compiling)
The verve example (the exe that come with the ) run without problems.
#2
In the meantime, have you checked your console log for any errors?
01/20/2010 (2:06 pm)
Stefano, please keep in mind that Monday was a holiday here in the States. I'm sure Phillip will get to your post soon, he may have missed it initially since it happened over the holiday weekend.In the meantime, have you checked your console log for any errors?
#3
Stefano, in order to use Verve you must compile your project after you add the source files. If you continue to have an issue, please give me more detail about what is going wrong. The console log is the best place to start and you will also need to tell me what you were doing when it crashed.
Cheers.
01/20/2010 (4:22 pm)
Sorry about the delay!Stefano, in order to use Verve you must compile your project after you add the source files. If you continue to have an issue, please give me more detail about what is going wrong. The console log is the best place to start and you will also need to tell me what you were doing when it crashed.
Cheers.
#4
I did not known that monday was a holiday. Excuse me.
I will try to compile my project.
Thank you very much again,
stefano.
01/22/2010 (9:38 am)
Thank you for the answer.I did not known that monday was a holiday. Excuse me.
I will try to compile my project.
Thank you very much again,
stefano.
Torque Owner Stefano Santo Sabato
MediaSoft s.r.l.
no answer ???
a very good customer services ...
thank you