Torque Constructor Won't Work.
by Timothy Volpe · in Hardware Issues · 12/29/2009 (3:45 pm) · 4 replies
I started up my construcotr today (It worked yesterday D=) and I was going to work on one of my interiors, but this is what I saw (Picture), and it didn't change. It thought maybe I should open the project, so i did it loaded- nothing. I can open windows and use controls and menus, but I can't see my project. Please help me.
Broke.
Hardly fits on the page -_-
Broke.
Hardly fits on the page -_-
#2
12/29/2009 (6:35 pm)
I had this happen to me once. I went to the top menu-> Layout-> Layouts-> Constructor Default and it reset itself. 
#3
12/29/2009 (7:36 pm)
Same thing happened to me a while back. I think I just minimized/maximized it or reloaded the menus like mentioned above. It happened every now and then, but was easily repaired.
#4
12/29/2009 (8:40 pm)
Ok, thanks Britt, it work. 
Torque 3D Owner Sherman Pendley
So what happened in between? System update, new software installed, prankster roommate or sibling, etc.? Have you scanned for viruses, trojans, and other nastiness recently?