Game Development Community

Error in Torque Constructor...

by Mie · in Artist Corner · 11/12/2008 (7:48 am) · 10 replies

Im creating my building per level... just when i tried to combine it all... the Torque Constructor is error...

and without any explanation of the error... i just being kicked... and after that im running my TC again... but the interface is error like the image i upload here...

can i fix this error? and how?

should i reinstall TC again??

why is this happens? (i tried to restart my computer.. but its still the same)

http://i56.photobucket.com/albums/g200/CinXz/error.jpg
NextNext Thread
PrevPrevious Thread
More from Artist Corner


Torque 3D Owner Edward
#1
11/12/2008 (8:04 am)
Hmm well, depending on the size of your level, It might be running out of memory. You should try exporting each level by itself and piece it together in the map. It might work better as a whole as well, exporting and if you need to alter a piece. and looking at your picture, i would say thats probably exactly whats happening. bigger is not always better.

Mie
#2
11/12/2008 (10:15 am)
Ow.... i c... then... what must i do with my TC? re install?

Torque 3D Owner Edward
#3
11/12/2008 (10:22 am)
Hmm its likely if there is a error after you rebooted, you might need to.
make sure you get 1.0.5.1 its got some more fixes

Mie
#4
11/12/2008 (10:24 am)
Its already 1.0.5.1.... hehehehehe... okay... ill try to uninstall it... :D thx for helping... :D

Mie
#5
11/12/2008 (7:05 pm)
Its fixed already... :D but another question.... in torque... after i put my building... i can move through of some of my building walls and floors.. why is this happening?

Torque 3D Owner Edward
#6
11/12/2008 (7:15 pm)
Ah this is usually caused by a bad export. The fixes for this varies from case to case. A reexport could fix it. Also its possible there is a bad face saved there, replacing the entire brush sometimes solves that issue. Also sometimes if you save it, close the program and restart it, it will alert you to these automatically. Its not very scientific, But note the walls that are not working properly and replace them as a rule. It should help. Also if you have a very complex building that can cause some issues.

Mie
#7
11/14/2008 (6:45 am)
Hmmm... i found something weird.... when i put all level of my building... it goes error "walk through" on floor and walls... but when i test per level.. all levels are ok... no "walk through" how can i fix this...?

Torque 3D Owner Edward
#8
11/14/2008 (6:56 am)
I have never seen this error, sorry. Cant help you on that one.

Associate David Montgomery-Blake
David MontgomeryBlake
#9
11/24/2008 (8:58 pm)
That sounds like a very old error with the original download. Are you sure you are patched?

Mie
#10
11/27/2008 (10:45 pm)
Sure im patched... ^^ its ok now... when i save it and restart the TC.. it goes fine... ^^ thx anyway..