Constructor forum
by Randy Thomas · in Artist Corner · 08/27/2008 (7:38 pm) · 3 replies
Sorry if this is in the wrong forum, but I couldn't find a constructor specific forum. Constructor has been working fine for me until recently. All of a sudden when I export a DIF file into TGE only one or two of the walls are solid, my avatar can walk through all of the others. Has anyone else had a problem like this? I went back and opened a different model that worked fine and when I reexported it, walls were suddenly no longer solid. I'm on a Mac so Quark isn't an option and I'd really hate to create all of this stuff in Blender and use collision boxes. (assuming I can do that). Does anyone have any advice?
Thanks
Thanks
About the author
#2
To check this, go to the "Community" link at the top of this page and select "Forums". Near the top of that page should be a link to "Edit" your subscriptions. Click that and see if the Constructor forums are turned on/off.
08/28/2008 (6:00 am)
Can't help with the Constructor problem, but you may not be seeing the forum because it is turned off in your options.To check this, go to the "Community" link at the top of this page and select "Forums". Near the top of that page should be a link to "Edit" your subscriptions. Click that and see if the Constructor forums are turned on/off.
William Clark
you may have brushes colliding im not sure another thing i found through hours of searching forums is turn of your remove hidden brushes function if either of these do not work you can mark your brushes as detail brushes.
I think your problems colliding brushes to be honest check out my site I have a few helpful links i have collected from all over the place over the last 6 month i have been using constructor.
http://sites.google.com/a/visionsdev.com/billbops-brain/Home
Good luck
Billbop_Visions