Stray sphere
by moebious · in Constructor · 04/16/2007 (4:38 pm) · 2 replies
Sometimes when i make spheres they jump out of the bounding box before i close the tool, and stay there after.
About the author
#2
when i manipulate the bounding box the pink wireframe shows it changing shape, until i let go of the button,then it dissapears again.
this isnt a pressing issue for me, ill just use one that works.
i just wanted to point out a glitch.
04/16/2007 (9:25 pm)
The spheres in question are regular, square, z-oriented and snapped to grid. when i raise the sides and segments to say 12 sides 6 segments, the sphere jumps out of the bounding box. The center of the sphere goes to the top of the bounding box. 12/6 is only one instance. it jumps up and down.when i manipulate the bounding box the pink wireframe shows it changing shape, until i let go of the button,then it dissapears again.
this isnt a pressing issue for me, ill just use one that works.
i just wanted to point out a glitch.
Torque 3D Owner Kenneth Holst
Default Studio Name