Game Development Community

Need Help

by Saul C. · in Torque Game Engine · 08/29/2006 (12:35 pm) · 3 replies

Ok, I bought TGE SDK 1.4 about a week ago. I purchased it at work and downloaded it (T1 vs dial-up at home), copied it the my stick, which had plenty of room, and brought it home. Upon arriving, I installed it. All there was were the starter kits, and the TGE demo. I wrote GarageGames and they said to look under the /engine directory and that the source code would be there. There are many folders under the /engine directory and many C++ files. Am I supposed to compile these files? Please help!

Thanks,
Saul
NextNext Thread
PrevPrevious Thread
More from Torque Game Engine


Torque Owner Isaac Dutton
#1
08/29/2006 (12:48 pm)
Haha, man have I been where you are lets see if I can dig you up some good reading on compiling 1.4

.... papers flying.... sounds of discs crunching agsent the wall.......

ahh yes here we go

http://tdn.garagegames.com/wiki/Torque/vs2k5


That should get you trucking, and compiling with the free compile microsoft offers, have any other problems just let me know!

Torque Owner Saul C.
#2
08/29/2006 (1:39 pm)
Thanks! That helped a lot, but I still have one little problem... my compiler version is the Microsoft Visual C++ 6.0... could you "translate" the controls to this version? Thanks again.

Torque Owner Isaac Dutton
#3
08/29/2006 (1:57 pm)
Http://www.garagegames.com/docs/tge/general/apbs02.php

there ya go bud

However, just for further note, I want ya to know all I am doing is searching at the top left of the screen. Not that its a bother helping you, but you may find results much faster!