Water Block position
by Simon Brain · in Torque Game Engine · 05/01/2006 (10:07 am) · 2 replies
I am new to Torque and am using the world editor to create terrains. When I insert a water block it appears high up in the sky above ground level. I woudl also like to know how to change the depth of the water.
Any help greatly appreciated.
Simon
Any help greatly appreciated.
Simon
#2
If your having an issue selecting the waterblock with manpulating it this will help you. I had a lot of issues with waterblocks until I discovered this.
- Dennis
05/03/2006 (7:14 am)
tdn.garagegames.com/wiki/Beginner/Torque_BugsIf your having an issue selecting the waterblock with manpulating it this will help you. I had a lot of issues with waterblocks until I discovered this.
- Dennis
Torque Owner Rojalee
there are three numbers in the location section of your waterblock.
if you change the third number to a lower setting (I would try 5 units at a time) you should see your waterblock get lower and lower until it is below or even with your ground.