Help in training
by WolfIK · in General Discussion · 07/10/2005 (12:43 pm) · 1 replies
Hello!
Excuse for bad English.
Probably it is a question set many times... But I have not found on him(it) the answer on a forum.
As the engine Torque in training for the people which badly know Visual. Whether it is possible without good knowledge Visual to learn well to work with Torque?
As in Internet absolutely there are no documentation on Torque except for as this site.
Prompt the documentation for the beginners with which it was possible to begin training Torque.
And if I shall buy Torque I shall receive more opportunities to learn to work with him?
Thanks for the answers!
And sorry for bad English!
Excuse for bad English.
Probably it is a question set many times... But I have not found on him(it) the answer on a forum.
As the engine Torque in training for the people which badly know Visual. Whether it is possible without good knowledge Visual to learn well to work with Torque?
As in Internet absolutely there are no documentation on Torque except for as this site.
Prompt the documentation for the beginners with which it was possible to begin training Torque.
And if I shall buy Torque I shall receive more opportunities to learn to work with him?
Thanks for the answers!
And sorry for bad English!
Greg Berkhof
Torque is based in C++, so if the Visual you are refering too is something like Visual C++, you should be at home, except for the User Interface creation of VC++, as torque is just plain old C++. If you are refering to Visual Basic, then no, its not very similar, as its an entirely different language.
When you purchase Torque, you do get full documentation on it, more then whats avalible on this site. I hope that answers your quesion.