[Feature Request] 1.1 Preview - Add "CSG Subtract" to Sketch Tool.
by Dmitry Koteroff · in Torque 3D Professional · 04/08/2011 (10:31 am) · 0 replies
Like in UDK (http://www.youtube.com/watch?v=1w1FffsRB3U, rewind to 00:56).
Small, but very helpful feature. Especially for make windows in walls.
Availability of "CSG Deintersect"-like feature would be very good too, but I asking too much, may be ;)
Currently, Sketch Tool not much suitable for prototyping.
Thanks for attention.
Small, but very helpful feature. Especially for make windows in walls.
Availability of "CSG Deintersect"-like feature would be very good too, but I asking too much, may be ;)
Currently, Sketch Tool not much suitable for prototyping.
Thanks for attention.
