Showtool Pro and Windows 7
by Frederick Leeming · in Artist Corner · 10/26/2009 (12:09 am) · 9 replies
Not sure if this is the right place to be posting this as I’m new to Torque.
Upgraded my system to windows 7 after running compatibly program and finding no errors.
Tried to run Showtool Pro and received the error message, “Error allocating virtual memory"
Please advise.
Fred
Upgraded my system to windows 7 after running compatibly program and finding no errors.
Tried to run Showtool Pro and received the error message, “Error allocating virtual memory"
Please advise.
Fred
#2
All other programs I'm running work ok including current Torque 3D.
10/26/2009 (1:02 am)
Not since update to windows 7 but they were current drivers and Windows 7 compatability tool showed no errors regarding drivers.All other programs I'm running work ok including current Torque 3D.
#3
10/26/2009 (1:17 am)
May I be as bold to ask your windows 7 version and if you have XPmode installed for virtual use ?
#4
Windows 7 version is "Home Premium" I updated from Vista Home Premium using an update version and not full install. I'll be open and frank with ya by saying I have no idea about XPmode for virtual use
10/26/2009 (1:31 am)
You may be as bold as you like.Windows 7 version is "Home Premium" I updated from Vista Home Premium using an update version and not full install. I'll be open and frank with ya by saying I have no idea about XPmode for virtual use
#5
I was going to suggest that you could run the program in XPmode but that mode is only available to Windows7Professional(or higher) users.
- I hope this can get sorted soon.
10/26/2009 (1:53 am)
ok, nevermind me then Fred. I was going to suggest that you could run the program in XPmode but that mode is only available to Windows7Professional(or higher) users.
- I hope this can get sorted soon.
#6
10/26/2009 (2:00 am)
NP. Thanks for your reply. 
#7
EDIT:
It ran out of the box, without any compatibility mode settings in effect. I have reduced the Aero options because this station is older, however.
10/26/2009 (11:07 am)
I have no problem running it on W7 Enterprise 64b with the latest manufacturer drivers for my hardware. EDIT:
It ran out of the box, without any compatibility mode settings in effect. I have reduced the Aero options because this station is older, however.
#8
10/30/2009 (5:14 am)
Recent move to win7 32 over here...& it runs fine.
#9
10/30/2009 (5:11 pm)
Thanks guys, I reinstalled and ran again. Working fine now. Must have been a glitch of some kind first time around.
Torque Owner Javier Canon